Cisco Bug: CSCvs54882 - Custom privilege commands do not show in running configuration and are lost on reload
Nov 06, 2020
- Cisco 2600 Series Multiservice Platforms
Known Affected Releases
Symptom: Privilege commands are not showing in the running-config and therefore are not written to the startup-config causing the privilege commands to be lost on reload of the device. Example Configuration: (config)#privilege interface level 10 switchport mode access (config)#privilege interface level 10 switchport access vlan Only the following shows in the running-configuration: privilege interface level 10 switchport <<<<<<< However, the more specifics are allowed until the device is reloaded, then the device reverts to only the commands seen in the running-configuration (I.E - switchport prompt only with no sub commands allowed). Conditions: Catalyst 9k running 16.6.6 or 16.9.4.
Bug details contain sensitive information and therefore require a Cisco.com account to be viewed.
Bug Details Include
- Full Description (including symptoms, conditions and workarounds)
- Known Fixed Releases
- Related Community Discussions
- Number of Related Support Cases