Guest

Preview Tool

Cisco Bug: CSCus45533 - Config discrepancy in REP due to this some features get impacted

Last Modified

Apr 01, 2016

Products (1)

  • Cisco ONS 15454 Series Multiservice Provisioning Platforms

Known Affected Releases

10.30

Description (partial)

Symptom:
In REP, while applying the configuration getting error message like "STCN port and REP port must be unique" where as both STCN and REP ports are same.

Conditions:
Steps to Reproduced
====================
Create Segment using below steps:
1. Verify that the GE_XP, 10GE_XP, GE_XPE, or 10GE_XPE card is installed in L2-over-DWDM mode
2. In card view, click the Provisioning > REP > Segment tabs.
3. Click Create.
4. Enter the segment ID in the Segment field. The range of the segment ID is from 1 to 1024.
5. From the Port drop-drown list, choose a REP port that must belong to this segment.
6. From the Port Role area, choose as an edge port.
7. From the STCN area, configure the destination of STCN messages
8. From the VLAN Load Balancing area, configure VLAN Load Balancing on the primary edge port
9. Click Next.
10. "STCN port and REP port must be unique" error message is observed
Bug details contain sensitive information and therefore require a Cisco.com account to be viewed.

Bug Details Include

  • Full Description (including symptoms, conditions and workarounds)
  • Status
  • Severity
  • Known Fixed Releases
  • Related Community Discussions
  • Number of Related Support Cases
Bug information is viewable for customers and partners who have a service contract. Registered users can view up to 200 bugs per month without a service contract.