Guest

Preview Tool

Cisco Bug: CSCus14568 - seamless upgrade on spyker A floods error messages to both asa units

Last Modified

Nov 09, 2016

Products (1)

  • Cisco ASA 5500-X Series Firewalls

Known Affected Releases

100.13(1.24) 9.3(2)

Description (partial)

Symptom:
The following error message floods the console of both the primary during step of a seamless upgrade operation from any build 9.3.1 or older to 9.3.2 and newer:

Number of interfaces on Active and Standby are not consistent.
If the problem persists, you should disable and re-enable failover 
on the Standby.

Conditions:
There is a phase in the seamless upgrade operation when the primary asa has a different image on it than the secondary.  During this phase, a stream of debug messages will continually get generated to the console.

It appears as though these messages are only a nuisance and they will subside once both units are returned to a state where they are both running the same image.

The event stream is somewhat of a flood but not bad enough to prevent basic control of the seamless upgrade procedure.
Bug details contain sensitive information and therefore require a Cisco.com account to be viewed.

Bug Details Include

  • Full Description (including symptoms, conditions and workarounds)
  • Status
  • Severity
  • Known Fixed Releases
  • Related Community Discussions
  • Number of Related Support Cases
Bug information is viewable for customers and partners who have a service contract. Registered users can view up to 200 bugs per month without a service contract.