Cisco Bug: CSCur21974 - UCS-E Network Config doesn't propagate when moving from router to router
Nov 14, 2016
- Cisco UCS E-Series Software
Known Affected Releases
1.0(0.0) 2.4(1.0) 3.0(2) 3.1(0.0)
Symptom: When configuring a UCS-E blade in a router, it is possible that the configuration will stick with the blade when moving/inserting into a different router where the blade was previously configured. Conditions: Condition happens when you move a blade from router to router where the blade is configured with different IP's on each G2 router. It only happens when the router is powered down, blade inserted, then router powered on. If the blade is hot inserted into a 3900 series router, this will not be an issue, nor is it an issue in the 4451.
Bug details contain sensitive information and therefore require a Cisco.com account to be viewed.
Bug Details Include
- Full Description (including symptoms, conditions and workarounds)
- Known Fixed Releases
- Related Community Discussions
- Number of Related Support Cases