Guest

Preview Tool

Cisco Bug: CSCup37172 - Unified WLC Config guide / Client location calibration

Last Modified

May 05, 2016

Products (1)

  • Cisco 5500 Series Wireless Controllers

Known Affected Releases

7.4

Description (partial)

Symptom:
Unified WLC's Config guide needs updating to remove deprecated command
Configuration Guides still list the following command:
config client location-calibration { enable | disable} client _mac interval_seconds
This appears to have been deprecated in earlier releases

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_010000111.html#ID2083

Conditions:
Configuring CCX Radio Management (CLI)

Step 1   	Globally enable CCX radio management by entering this command:

config advanced { 802.11a | 802.11b} ccx location-meas global enable interval_seconds

The range for the interval_seconds parameter is 60 to 32400 seconds, and the default value is 60 seconds. This command causes all access points connected to this Cisco WLC in the 802.11a or 802.11b/g network to issue broadcast radio measurement requests to clients running CCXv2 or later releases.
Step 2   	Enable access point customization by entering these commands:

    config advanced { 802.11a | 802.11b} ccx customize Cisco_AP { on | off} This command enables or disables CCX radio management features for a particular access point in the 802.11a or 802.11b/g network.
    config advanced { 802.11a | 802.11b} ccx location-meas ap Cisco_AP enable interval_seconds The range for the interval_seconds parameter is 60 to 32400 seconds, and the default value is 60 seconds. This command causes a particular access point in the 802.11a or 802.11b/g network to issue broadcast radio measurement requests to clients running CCXv2 or higher.

Step 3   	Enable or disable location calibration for a particular client by entering this command:

config client location-calibration { enable | disable} client _mac interval_seconds
Note    	

You can configure up to five clients per Cisco WLC for location calibration.
Step 4   	Save your settings by entering this command: save config
Bug details contain sensitive information and therefore require a Cisco.com account to be viewed.

Bug Details Include

  • Full Description (including symptoms, conditions and workarounds)
  • Status
  • Severity
  • Known Fixed Releases
  • Related Community Discussions
  • Number of Related Support Cases
Bug information is viewable for customers and partners who have a service contract. Registered users can view up to 200 bugs per month without a service contract.