Guest

Preview Tool

Cisco Bug: CSCul36989 - Uplink network port status on UCSM GUI is Access while Trunk on nxos

Last Modified

Feb 14, 2018

Products (1)

  • Cisco Unified Computing System

Known Affected Releases

2.0(3a)C

Description (partial)

Symptom:
The uplink network port interface status on UCSM GUI is access while it's shown trunk using NX-OS CLI output.

UCSMB Eth1/19
=================================
Ethernet1/19 is up
  Hardware: 10000 Ethernet, address: 0005.9b72.461a (bia 0005.9b72.461a)
  Description: U: Uplink
  MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA
  Port mode is trunk
  full-duplex, 10 Gb/s, media type is 10G
  Beacon is turned off
  Input flow-control is off, output flow-control is off
  Rate mode is dedicated
  Switchport monitor is off
  EtherType is 0x8100
  Last link flapped 00:21:06
  Last clearing of "show interface" counters never
  30 seconds input rate 6632 bits/sec, 829 bytes/sec, 5 packets/sec
  30 seconds output rate 96 bits/sec, 12 bytes/sec, 0 packets/sec
  Load-Interval #2: 5 minute (300 seconds)
    input rate 7.62 Kbps, 13 pps; output rate 120 bps, 0 pps
  RX
    7626 unicast packets  9638767 multicast packets  8 broadcast packets
    9646401 input packets  654328045 bytes
    0 jumbo packets  0 storm suppression packets
0 giants      0 input error  0 short frame  0 overrun   0 underrun      0 watchdog  0 if down drop
    0 input with dribble  0 input discard
    0 Rx pause
  TX
    7428 unicast packets  2227 multicast packets  1364 broadcast packets
    11019 output packets  1177785 bytes
    0 jumbo packets
    0 output errors  0 collision  0 deferred  0 late collision
    0 lost carrier  0 no carrier  0 babble
    0 Tx pause
  6 interface resets
=================================

The communication through the interface is no problem, so it should be Trunk also an  the GUI. The transceiver status wasn't also displayed on the GUI.

Conditions:
An interface is configured as network uplink port
Bug details contain sensitive information and therefore require a Cisco.com account to be viewed.

Bug Details Include

  • Full Description (including symptoms, conditions and workarounds)
  • Status
  • Severity
  • Known Fixed Releases
  • Related Community Discussions
  • Number of Related Support Cases
Bug information is viewable for customers and partners who have a service contract. Registered users can view up to 200 bugs per month without a service contract.