Cisco Bug: CSCtd80590 - Increase syslog message level for core file transfer failures
Feb 06, 2017
- Cisco 12000 Series Routers
Known Affected Releases
Symptom: Standby PRP3 stuck in IOX-PREP state for 18minutes and get reloaded by sysldr on active PRP3 with "MBI cannot load IOX" reason Active PRP3 has cfgmgr-rp process crash. The core file for cfgmgr-rp process is not present in any of the hard disks. No log message about the failure of core file transfer on active RP console. Conditions: Preimage 4 PRP3s with 3.8.1, configure them to boot from rommon. Insert 4 PRP3s in 12816 chassis in slot0, 1, 8 and 9 respectively. When all are in rommon, configure PRP3s in slot0 and slot1 to load the image from disk0: (where the image was pre-imaged) Reset PRP3 in slot0. Give 20seconds gap and reset PRP3 in slot1.
Bug details contain sensitive information and therefore require a Cisco.com account to be viewed.
Bug Details Include
- Full Description (including symptoms, conditions and workarounds)
- Known Fixed Releases
- Related Community Discussions
- Number of Related Support Cases