Preview Tool

Cisco Bug: CSCta40657 - After re-enable ha-autosync, the context in standby didn't do CLI sync

Last Modified

May 06, 2011

Products (1)

  • Cisco Application Networking Manager

Known Affected Releases


Description (partial)

In Admin HA Setup page, re-enable FT group "Autosync Run" and deploy. Once done, ACE will do a bulk copy from Active to standby side, but ANM doesn't. As the result, the standby context on ANM could be inconsistent with ACE.

Two ACEs are configured for HA, and some contexts are in FT group, but their "Autosync Run" is disabled. In this case, ANM and ACE allow to make configuration change on both Active and Standby Hot separately. 

The problem occurs when "Autosync Run" is enabled again.
Bug details contain sensitive information and therefore require a account to be viewed.

Bug Details Include

  • Full Description (including symptoms, conditions and workarounds)
  • Status
  • Severity
  • Known Fixed Releases
  • Related Community Discussions
  • Number of Related Support Cases
Bug information is viewable for customers and partners who have a service contract. Registered users can view up to 200 bugs per month without a service contract.