Cisco Bug: CSCsz96318 - NM-1T3/E3: clear counter resets alarm to receiver loss of signal in T3
Mar 26, 2010
- Cisco IOS
Known Affected Releases
Symptom: <CmdBold> show controller t3 <noCmdBold> shows alarm status as "Receiver has loss of signal" when NM-1T3/E3 module is configured in T3 mode and when controller T3 link stays up. Conditions: Issuing <CmdBold> clear counters <noCmdBold> in ISR 4 to 5 times continuously will reset alarm status from "No alarms detected" to "Receiver has loss of signal". This problem does not happen when NM-1T3/E3 is configured in E3 mode. No functional impact is observed so far.
Bug details contain sensitive information and therefore require a Cisco.com account to be viewed.
Bug Details Include
- Full Description (including symptoms, conditions and workarounds)
- Known Fixed Releases
- Related Community Discussions
- Number of Related Support Cases