Cisco Bug: CSCsy96062 - Line Card is resetting when reaching the MAX(64) wred profiles on SIP601
Feb 22, 2014
- Cisco 12000 Series Routers
Known Affected Releases
Symptom: - SPA HEARTBEAT %SPA_PLIM-3-HEARTBEAT: Subslot 1 has experienced an heartbeat failure Current Sequence 11071 received Sequence 11059 Time since last keep 232ms.LC CPU load 25% %LC-4-HEARTBEATINFO: END OF HB FAILURE INFO - SPA becomes stuck Executing "sh controll frf qm reg x" and seeing the following: Interrupt Status Register: 0x4100000000000000. it is because it is stuck. Usually 0x40 or 0x41. If it was free, it should be 0x0000000000000000 - THEN PLIM MAPPING PROBLEMS %EELC_QOS_RES_MGR-3-TX_PORT_TO_PLIM_MAPPING_FAILED: Mapping of tx_port to PLIM failed. tx_port = 2198 -Traceback= 40031128 407002D0 4071194C 40711BD4 40714C7C 40636490 40717BCC 40707F88 407080F4 40755F04 40345F74 40756B4C 4075667C 408BD854 408E8224 40731200 - FOLLOWED BY AUTOMATICALLY SPA reset %SPA_OIR-6-OFFLINECARD: SPA (SPA-1XCHSTM1/OC3) offline in subslot3/3 SLOT 3: %SPA_PLUGIN-6-SPI4_SYNC: SPA-1XCHSTM1/OC3[3/1]: SPI4 bus synchronization achieved. SLOT 3: %SPA_PLUGIN-6-FIRMWARE_DOWNLOADING: SPA-1XCHSTM1/OC3[3/1]: Downloading SPA firmware (bundled)... %SPA_OIR-3-RECOVERY_RELOAD: subslot 3/1: Attempting recovery by reloading SPA SPA_OIR-6-OFFLINECARD: SPA (SPA-1XCHSTM1/OC3) offline in subslot 3/1 Conditions: - GSR running 12.0(32)SY6e - SIP601 with a CHSTM1 SPA - WRED configured on interfaces - Configuration exceeding the limit of 64 WRED profiles.
Bug details contain sensitive information and therefore require a Cisco.com account to be viewed.
Bug Details Include
- Full Description (including symptoms, conditions and workarounds)
- Known Fixed Releases
- Related Community Discussions
- Number of Related Support Cases